Monday, October 3, 2011

Back To Basics - OVER and PARTITION BY

I attended SQL Saturday #97 here in Austin this weekend. I had a blast and came out of it with a bunch of new knowledge. The last session that I attended was hosted by Jennifer McCown (blog|twitter) and named "T-SQL Brush-up: The Best Things You Forgot You Knew". It was very lively and informative and introduced me to some functions I knew about but hadn't really seen the potential of before: Partition and Over. Below are a couple of articles I found about the functions. Enjoy!

SQL Awesomesauce: Tip OVER and PARTITION BY
and
Eliminating Duplicate Rows using THE PARTITION BY Clause

Now, here is my usual rant about keeping to some sort of schedule, but you have probably figured out that it's not going to happen right now. The company I work for recently got acquired by a bigger company (which I am assuming the way it normally occurs) and we are beginning the integration process. The upside is I still have a job, the downside is that I am going to be very busy for the next three months (Well, its not that big of a downside, I would rather be busy than bored any day). I will try to do a few Back-To-Basic Mondays this Month and hope to get out at least one regular Blog post but we will see. Sorry.

RutherfordTX

2 comments:

  1. When this happens, the shutter opens to dump all of the cash which have been performed for the reason that} last jackpot. When you place a coin on this machine, it falls into a clear case. The backside of the case is a movable shutter that's linked to a metal linkage, as have the ability to|you possibly can} see in the diagram. But 카지노사이트 when the machine hits the jackpot, the third stopper shifts the linkage up, opening the shutter so the cash fall out of the machine. Independent candidate Andrew Wilkie, an anti-pokies campaigner, was elected to the Australian House of Representatives seat of Denison at the 2010 federal election. Wilkie was considered one of four crossbenchers who supported the Gillard Labor authorities following the hung parliament end result.

    ReplyDelete
  2. You’ll be able to|be succesful of|have the ability to} find initiatives with full guides and downloadable mannequin files. A 3D printing software works through the use of CAD software first to create the digital mannequin of a part or object that's to be printed. Then, a slicer software is used to break down this mannequin into a succession of slices. Without the slicer, Renpho Massagers the 3D printer will be unable to interpret the 3D mannequin. The information generated by the slicer program are despatched to the printer as step-by-step directions in G-code, and the half is then printed based on these machine directions.

    ReplyDelete